Sidel SBO replacement bulb 380V

Sat, 20 Jun 2026 04:14:04 +0800

When your Sidel SBO starts missing temperature setpoints, the whole line feels it. Preforms underheat, rejects stack up, and the machine slows down to chase the heat. You flip through the OEM catalog, then do the math on lead times and prices, and the maintenance budget just winces. That’s when a purpose-built Sidel SBO replacement bulb, 380V, makes sense. What matters, technically We build this emitter to sit in the SBO heating tunnel—geometry and electrical profile included. It runs 380V, so it matches the machine’s supply and control logic, and the heating curve behaves exactly the way the blow molder expects. The quartz halogen design throws short-wave infrared that cuts through the preform wall fast, giving quick response and repeatable results across the neck and body. Count on stable output past 5,000+ hours with minimal drift—exactly what you need for consistent stretch blow molding cycles. Why it works on the SBO On an SBO, heating is the pacing item. If the lamps lag, the entire machine waits. This replacement hits the same thermal response as the original, so you hold cycle time without chasing offsets. Power stays in line because the 380V match prevents over-current that wastes energy and stresses contactors. Fewer lamp changes per year, less downtime, and a heating profile that keeps bottle weight and clarity stable. A few shop-floor details Installation is straightforward, but the heating window is tight. Verify the R7s base orientation, and make sure the reflector is clean and seated squarely—misalignment creates hot spots and eats lamp life. And match the 380V rating to your supply. Drop in a lower-volt lamp on a higher-volt circuit, and it’ll burn fast. Follow the machine’s lamp schedule and replace in pairs to keep zone balance.

380V on Warm IR Heating Tubes

Sidel SBO replacement bulb 380V