Nights on the patio get sharp fast once the sun goes down. With infrared patio heaters, the usual story is uneven heat and wasted energy—cold spots on the floor and a hot strip right under the element. We tackled that by rethinking the reflector. What actually matters under the hood Infrared warmth is radiant heat, and the reflector is what directs that energy where it needs to go. We used geometric optics to shape the reflector into a compound parabolic profile, then added micro-facets to steer the beam. That gives us a controlled spread, so intensity stays even across the target area instead of peaking in the center and falling off at the edges. Pair that with a carbon fiber element and a high-reflectivity anodized aluminum surface, and you get more usable warmth per watt—delivered in a broad, even pattern. Why this matters on a chilly patio Comfort isn’t just about heat; it’s about coverage. A more uniform projection means people feel warmth across the whole seating area, not just in one hot zone. You also waste less energy on over-illumination and spill. The payoff is immediate: steady, draft-free warmth that keeps conversations going—and lower operating cost without cutting into comfort. What to get right on install Mount height and angle make the pattern work. Hang the heater 7–9 feet above the floor and angle it to cover the seating, not the table edge. Most units run on standard 120V or 240V circuits, so check your outlet and load before you order. One practical note: reflectors are bright and can feel warm up close. Position the unit to avoid direct eye contact and keep clearances clear.